Lenovo 5468 Setup Manual page 54

Thinksystem sd650 dual node dwc tray and nextscale n1200 dwc enclosure

Hide thumbs Also See for 5468:

Table of Contents

Figure 36. DIMM removal

Attention:

• DIMMs are static-sensitive devices. The package must be grounded before it is opened.

• To avoid breaking the retaining clips or damaging the DIMM connectors, open and close the

clips gently.

Step 3.

Touch the static-protective package that contains the DIMM to any unpainted metal surface on the

outside of the node. Then, remove the DIMM from the package.

Step 4.

Carefully insert the DIMM into the connector by aligning the edges of the DIMM with the slots at the

ends of the DIMM connector.

Step 5.

Firmly press the DIMM straight down into the connector by applying pressure on both ends of the

DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly

seated in the connector.

ThinkSystem SD650 Dual Node DWC Tray and NeXtScale n1200 DWC Enclosure Setup Guide

Table of Contents

7x58