Lenovo 5468 Setup Manual page 66

Thinksystem sd650 dual node dwc tray and nextscale n1200 dwc enclosure

Hide thumbs Also See for 5468:

Table of Contents

• "Installation Guidelines" on page 30

2. Reinstall the blank bezel filler if you have removed it.

Figure 53. Blank bezel filler installation

Complete the following steps to install the tray cover.

Watch the procedure. A video of the installation process is available:

• Youtube:

https://www.youtube.com/playlist?list=PLYV5R7hVcs-BHNs9o9uS9u93aeU5BCI8I

• Youku:

http://list.youku.com/albumlist/show/id_51372950.html

Step 1.

Position the cover on top of the tray.

Step 2.

Slide the cover toward the front of the tray.

Important: Before you slide the cover forward, make sure that all the tabs on the front, rear, and

side of the cover engage the enclosure correctly. If all the tabs do not engage the enclosure

correctly, it will be very difficult to remove the cover later.

Step 3.

Make sure that the cover correctly engages all the insert tabs on the tray.

Figure 54. Tray cover installation

After you install the tray cover, complete the following steps:

1. Reinstall the tray into the enclosure (see "Install a DWC tray in the enclosure" on page 63).

ThinkSystem SD650 Dual Node DWC Tray and NeXtScale n1200 DWC Enclosure Setup Guide

Table of Contents

7x58