Install The Tray Cover - Lenovo 5468 Setup Manual

Figure 51. PCIe riser-cage assembly installation
Step 5. Carefully route cables as illustrated.
Note: Ensure the IFT cable is routed in the notch and use the cable tie to collect cables.
Figure 52. Cable routing
After you install an IFT adapter, complete the following steps:
1. Reinstall the tray cover (see "Install the tray cover" on page 61).
2. Reinstall the tray (see "Install a DWC tray in the enclosure" on page 63).
3. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate
both nodes are ready to be powered on.

Install the tray cover

Use this information to install the tray cover.
Before you install the tray cover:
1. Read the following section(s) to ensure that you work safely.
.
Chapter 3 Solution hardware setup
61