Lenovo 5468 Setup Manual page 57

• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BHNs9o9uS9u93aeU5BCI8I
• Youku: http://list.youku.com/albumlist/show/id_51372950.html
Step 1. Locate the connector on each side of the M.2 backplane.
Notes:
• Some M.2 backplanes support two identical M.2 drives. When two drives are installed, align and
support both drives when sliding the retainer forward to secure the drives.
Step 2. Insert the M.2 drive at an angle (approximately 30 degrees) into the connector and rotate it until the
notch catches on the lip of the retainer; then, slide the retainer forward (toward the connector) to
secure the M.2 drive in the M.2 backplane.
Figure 39. M.2 drive installation
Attention: When sliding the retainer forward, make sure the two nubs on the retainer enter the
small holes on the M.2 backplane. Once they enter the holes, you will hear a soft "click" sound.
Figure 40. M.2 drive installation
After you install an M.2 drive into the M.2 backplane, complete the following steps:
1. Reinstall the M.2 backplane (see "Install the M.2 backplane" on page 54).
2. Reinstall the tray cover (see "Install the tray cover" on page 61).
.
Chapter 3 Solution hardware setup
53