Replacing The Battery Cartridge - Denso GT10Q-SB User Manual

2d code handy scanner
Table of Contents

Advertisement

10.2 Replacing the Battery Cartridge

The rechargeable battery cartridge is a consumable part with a finite service life. It is time to replace it when a full
charge lasts a significantly shorter time than previously. Note that the service life varies with usage conditions
Follow the replacement procedure given below also when it is necessary to take the battery cartridge out of the
scanner due to any scanner trouble.
(1) Remove the screw that secures the battery cover.
(2) Open the battery cover gently that is connected with the cable.
(3) Pull up the battery pull strap to take the battery cartridge out of the scanner.
(4) Disconnect the battery cable connector.
Note: When disconnecting the cable connector, be sure to hold the connector housings as shown below. Do not
pull the cables; doing so will result in broken wires.
Scanner
Battery cable
connector
50
Battery cover
Battery pull strap
Battery cartridge

Advertisement

Table of Contents
loading

Table of Contents