Denso GT10Q-SB User Manual page 64

(5) Connect a new battery cartridge to the battery cable connector.
Note: Do not peel off the protection film covering a battery cartridge.
(6) Insert the new battery cartridge into the scanner so that the battery pull strap is routed below the battery cartridge
as shown below.
(7) Route the cables in the space around the battery cartridge to prevent them from getting pinched between the
battery cover and the case, and then close the battery cover and secure it with the screw.
Note: After loading a new battery cartridge, be sure to charge it for at least 2.5 hours.
Battery cable
connector
Battery pull strap
Battery cable connector
Battery
pull strap
Charge
cable
connector
Battery cartridge
Battery cable
connector
Charge
cable
connector
Battery cartridge
51
Battery pull strap
Battery pull strap
Battery cartridge