Table of Contents
Advertisement
All manuals and user guides at all-guides.com
clamp and unscrew (not fully) the screws
in the mains terminal block “L N E” which
secure the three wires of the mains cable.
Fit the cable and refit screw “A” the cable
clamp (FIG. 19)..
Allow sufficient cable length for the cooker
to be pulled out for cleaning, but do not
let it hang closer than 50mm (2”) to the
floor. The cable can be looped if
necessary, but make sure that it is not
kinked or trapped when the cooker is in
position.
L
1
2
3
4
N
5
A
FIG. 19
E 14
25 W - 230 V~
T300°C
A
FIG. 20
ENGLISH
The wires in the mains lead are
coloured in accordance with the
following code:
Warning !
If the supply cable is damaged, it
must be replaced by the
manufacturer or by his after-sales
service, or by a similar qualified
person, in order to prevent any
risk.
Warning !
Isolate the cooker from the
electricity supply before attempting
to replace the oven lamp.
The oven lamp used is of a special type
withstanding high temperatures. To
replace it, act as follows: disassemble
the protecting glass (A) FIG. 20 and
replace the burnt lamp with one of the
same type. Reassemble the protecting
glass.
26
Advertisement
Table of Contents
