Siemens DataNET Hub (DNH) User Manual page 85

Command Descriptions,
2000585-001
Continued
dn portdelay time
The dn command is also used to enable and disable software tracing
inside the hub software. This is intended to provide a software debug
facility. The form for these commands is:
dn module on
dn module off
In order to collect software trace events in the log buffer, you must also
give the command "events on."
dn iframe on
The available modules are:
Traces software events specific to the cross link.
xlinktrace
Traces software events specific to the Ethernet in-
ethertrace
terface.
Traces software events for the DataNET driver
dntrace
Traces software events in the DataNET section's
lstrace
link state module.
Traces events specific to the "RXDONE" logic.
rxdonetrace
Traces software events specific to management of
sattrace
the Source Address Table (SAT)
Traces software events specific to processing I-
iframe
frames in the dn section.
Sets the "port delay" parameter to the
value given, in milliseconds. Actual times
are rounded down to the nearest ten mil-
liseconds.
Command Summary • • • • 77