Table of Contents
Advertisement
Solid Shortening:
Notice
-
If you have a machine that is designed to be
used with Liquid shortening and you wish to use Solid
shortening you will have to purchase and install a Solid
Shortening Kit. Call your Authorized Dealer for more
information.
CAUTION
If Solid shortening is used, 00 NOT attempt to mclt
the shortening in your fryer unless the controller is pro-
grammed with the melt cycle option programmed to
Solid Shortening. (The Digital display will show
uE~.
The Computer
control
will
show
fF(L T S~)
Improper operation or machine damage
coold occur.
Make sure the drain valve is completely closed.
remove the screen covering the tube if it is still in the
fry tank .
Cut the shortening into I" (2.5 cm) cubes. Always
pack the pieces of shortening below, beside and on
top of the heat tube. 00 NOT leave any large air
pockets and take care not to damage any sensor
probes.
1.
2.
3.
Start the fryer as described in the following section
and allow the fryer to automaticaly come up to tem-
perature. This will take approximately 1 hour and
should not be bypassed. The controller will melt the
shortening in short controlled bursts of heat. When
the oil has reached a temperature where it is liquid
the controller will automaticaly switch to a full run
condition and the shortening will now come up to
the desired temperature automaticaly.
Adding
When adding Solid shortening to a fry tank to "Top Off"
the oil 1evel the new shortening must be cut into 1" (2.5
cm) cubes and added piece by piece.
1. Always allow the fryer to operate for 5 to 10 minutes
after cooking has finished to allow filter time to clear
the oil.
2. Before the fryer is shut down for the night and while
the oil is still hot, follow the instructions on page 12
to change the Filter Bags.
3. On a fryer equipped with a Computer controller press
thc ON/OFF/START Switch to the OFF position and
thcn press the Control Circuit Breaker (#4, page 6)
to thc OFF position. On a fryer equipped with a Digi-
lal controller press the
~
key on the front panel.
Thc Digital Controller will now turn the fryer OFF.
Press the Control Circuit Breaker to the OFF posi-
tion.
4. If the fryer is to be left for an extended period of
time, such as overnight, turn the Gas Shut Off Valve
handle counter clockwise to shut the gas supply OFF.
8
Advertisement
Table of Contents
