Advertisement
CUTTING AIR LINES
Use a sharp knife or a hose cutter and make clean, square cuts (Fig. 9). Do not use scissors
or wire cutters because these tools will deform the air line. Do not cut the lines at an
angle. The minimum bend radius for 1/4" air line is 1" (25mm). Air lines are to be installed
straight into fittings. Inspect the air line for scratches that run lengthwise. Contact Air Lift
customer service if the air line is damaged.
6
Good cut
To watch a video demonstrating proper air line cutting, go to
air-lift.co/cuttingairline.
Bad cut
Fig. 9
MN-1092
Advertisement
