Allen-Bradley ControlNet PLC-5 User Manual page 130

D-10 ControlNet I/O Map-Entry Status Words and Error Codes
Decimal Hex. Code
Code
65530 0xFFFA
65531 0xFFFB
65532 0xFFFC
65533 0xFFFD
1785-UM022B-EN-P - February 2002
Error Message
MODULE DECLARED INVALID
LENGTH
INVALID READ DATA
INVALID WRITE DATA
DATA TABLE TOO SMALL
Explanation/Possible Cause(s)
A communication error between the
adapter and the module caused the
transfer to be aborted.
The target slot contains the wrong
module type.
An incorrect module or slot was
entered in the map table.
A communication error between the
adapter and the module caused the
transfer to be aborted.
The target slot contains the wrong
module type.
An incorrect module or slot was
entered in the map table.
A communication error between the
adapter and the module caused the
transfer to be aborted.
The target slot contains the wrong
module type.
An incorrect module or slot was
entered in the map table.
The processor data table is too small
to hold the data to be transferred.
Possible Corrective Action(s)
Make sure that the module is
properly seated in the correct slot of
the target node.
Make sure that the adapter's power
supply is providing the proper
voltage.
Insert the proper module in the
correct slot of the target node.
Edit the I/O map table to show the
correct module type and slot.
Make sure that the module is
properly seated in the correct slot of
the target node.
Make sure that the adapter's power
supply is providing the proper
voltage.
Insert the proper module in the
correct slot of the target node.
Edit the I/O map table to show the
correct module type and slot.
Make sure that the module is
properly seated in the correct slot of
the target node.
Make sure that the adapter's power
supply is providing the proper
voltage.
Insert the proper module in the
correct slot of the target node.
Edit the I/O map table to show the
correct module type and slot.
Increase the size of the data table to
accommodate the transfer length.