Allen-Bradley ControlNet PLC-5 User Manual page 105

S:11
This word of
the status file:
S:10/04
S:10/05
S:10/06
S:10/07
S:10/08
S:10/09
S:10/10
S:10/11
S:10/12
S:10/13
S:10/14
This word of
the status file:
S:11 major fault word
S:11/00
S:11/01
S:11/02
S:11/03
S:11/04
S:11/05
S:11/06
S:11/07
S:11/08
S:11/09
S:11/10
S:11/11
AB Drives
Processor Status File
Stores:
Edits prevent SFC continuing; data table size changed during
program mode; reset automatically in run mode
Invalid I/O status file
reserved
No more command blocks exist to execute block-transfers
Not enough memory on the memory module to upload the program
from the processor
No MCP is configured to run
MCP not allowed
PII word number not in local rack
PII overlap
no command blocks exist to get PII
Arithmetic overflow
Stores:
Corrupted program file (codes 10-19). See major fault codes (S:12).
Corrupted address in ladder program (codes 20-29). See major
fault codes (S:12).
Programming error (codes 30-49). See major fault codes (S:12).
Processor detected an SFC fault (codes (71-79). See major fault
codes (S:12).
Processor detected an error when assembling a ladder program file
(code 70); duplicate LBLs found.
Start-up protection fault. The processor sets this major fault bit
when powering up in Run mode if the user control bit S:26/1 is set.
Peripheral device fault
User-generated fault; processor jumped to fault routine (codes 0-9).
See major fault codes (S:12).
Watchdog faulted
System configured wrong (codes 80 - 82, 84 - 88, 200 - 208). See
major fault codes (S:12).
Recoverable hardware error
MCP does not exist or is not a ladder or SFC file
1785-UM022B-EN-P - February 2002
B-3