Operations - KING One Pro KOP4800 Owner's Manual

5 .5 When test is complete, a screen similar to the one below should appear .
Because receivers are always changing, screen graphics may vary.
MUST SHOW
"SW21" or
"SW21-3SAT"
NO "X"s
If the indicated results are not obtained, go back to Step 5 .1 and run test again . Contact KING
if the check switch fails to load after 4 attempts .
5 .6 When the installation summary shows the successful check switch test results, save the
settings, exit to the main menu screen and wait for programming to download .
5.7 When programming has downloaded, select your desired channel. Enjoy!
For standard operation, make all connections and start a scan (step 4), then wait for
programming to download, select your desired channel and watch TV.
If you move the vehicle, you will have to reacquire the satellites by repeating the scan process .
MODE 3 (Bell TV)
OPERATING NOTES:
Page 11