Check Switch Test - KING One Pro KOP4800 Owner's Manual

5
Run a check switch test . This is a one-time procedure unless noted in gray box below .
NOTE: The SW21 switch is a receiver software configuration that is loaded into the receiver after successfully running
a check switch test with the dish locked on and configured for the appropriate service.
Step 5 is a one-time procedure that will not need to be repeated after successful
installation, unless:
a) check switch test is run again while the receiver is connected to a home dish system .
b) check switch test is run when the receiver is not connected .
5 .1 On the receiver remote, press MENU, 6, 1, 1 .
5 .2 Highlight "Check Switch ."
Press SELECT on your remote .
NOTE: Some receivers may prompt you to select
"Check Switch" a second time to initiate
the test.
5 .3 Make sure "SuperDISH" and "Alternate" boxes
are NOT selected .
NOTE: Not all receivers will display a screen with
options that include "SuperDISH" and
"Alternate" boxes.
5 .4 Highlight "Test ."
Press SELECT on your remote .
The receiver will perform a check switch test . This process can take a little while so
PLEASE BE PATIENT .
Page 10

CHECK SWITCH TEST

Screen graphics may vary.