appropriate service.
This is a one-time procedure that will not need to be repeated after successful installation,
unless:
a) check switch test is run again while the receiver is connected to a home dish system.
b) check switch test is run when the receiver is not connected.
1. On the receiver remote, press MENU, 6, 1, 1.
2. Highlight "Check Switch."
Press SELECT on your remote.
NOTE: Some receivers may prompt you to select
"Check Switch" a second time to initiate
the test.
3. Make sure "SuperDISH" and "Alternate" boxes
are NOT selected.
NOTE: Not all receivers will display a screen with
options that include "SuperDISH" and
"Alternate" boxes.
4. Highlight "Test."
Press SELECT on your remote.
The receiver will perform a check switch test. This process can take a little while so
PLEASE BE PATIENT.
Page 12
RUN CHECK SWITCH
Screen graphics may vary.