Ambient Temperature - Siemens Pointek CLS200 Quick Start Manual

Pointek CLS200/300 (Digital)
Note: Pointek CLS200/300 is to be used only in the manner outlined in this manual, otherwise
protection provided by the equipment may be impaired.
This product is intended for use in industrial areas. Operation of this equipment in a
residential area may cause interference to several frequency based communications.
Pointek CLS200/300 is a versatile capacitance
switch with a high level of chemical
resistance; ideal for level detection of
interfaces, solids, liquids, slurries, and foam,
and for simple pump control.
Approvals (verify against
device nameplate)
• CE, CSA , FM, ATEX
C/US
• Vlarem II, WHG
• Lloyd's Register of Shipping, categories
ENV1, ENV2, and ENV5
Note: The use of approved watertight conduit hubs/glands is required for Type 4 / NEMA 4,
Type 6 / NEMA 6, IP68 (outdoor applications). For CE requirements, the use of EMC-rated
cable entries is required.
Process connections
Compact (std.) configuration
Sanitary configuration
Cable and slide coupling
configuration

Ambient temperature

• General applications
- local display
- storage temperature
• In potentially explosive atmospheres
Process Conditions
Please see full Operating Instructions for Process Pressure/Temperature De-
Note:
rating Curves.
• relative dielectric constant (
• CLS200 temperature
- without thermal isolator -40 to +85 °C (-40 to +185 °F)
- with thermal isolator
1.
At process connection.
7ML19985XA82
R ¾", 1", 1 1/4", 1 ½" BSPT; ¾", 1", 1 1/4", 1 ½" NPT; G ¾", 1",
1 ½" BSPP
1", 1 ½", 2", 2 ½"and 3" tri-clamp
R ¾", 1", 1 1/4", 1 ½" BSPT; ¾", 1", 1 1/4", 1 ½" NPT (Taper);
G ¾", 1", 1 ½" BSPP
1.5 minimum
r
1
:
-40 to +125 °C (-40 to +257 °F)
Pointek CLS200/300 (Digital) – QUICK START MANUAL
Digital version
lid with window
device
nameplate
-40 to +85 °C (-40 to +185 °F)
-30 to +85 °C (-22 to +185 °F)
-40 to +85 °C (-40 to +185 °F)
(check temperature class shown on device
nameplate)
integral digital display
optional M12 plug
available
Page EN-3