System Circuit Breaker; Elapsed Time Meter; Control Circuit Breaker; Power On Indicator - HELIX 9600 Installation, Operation And Maintenance Instructions

High voltage compressor

Hide thumbs Also See for 9600:

Table of Contents

System Circuit Breaker

The System Circuit Breaker protects main input power to the Compressor

pump and module. The circuit breaker positions are labeled ON (1), which

is in the UP position, and OFF (0), which is in the DOWN position.

NOTE: The phase monitor in the Compressor will cause the system circuit

breaker to open when input power phases are incorrect.

The Elapsed Time Meter records the number of Compressor operating

hours. Since the meter is digital, it is not illuminated unless the system

circuit breaker is in the ON position and power is connected to the

Compressor. The Elapsed Time Meter maintains the correct accumulated

operating hours while system power is turned OFF.

NOTE: The meter cannot be reset.

The Control Circuit Breaker provides current overload protection for all

internal components of the Compressor except the Compressor motor. The

Compressor motor is protected by a separate overload protector. The

Control Circuit Breaker opens automatically and must be reset manually.

The Power On Indicator illuminates when the system circuit breaker is

placed in the ON position. The Compressor pump is energized when the

power indicator is illuminated and the elapsed time meter records system

operation time.

The Gas Charge Flared Fitting is used to connect a 99.999% pure helium

supply to the Compressor when helium charging is required. The fitting has

a 45 º flare and 7/16 in. x 20 threads/inch. Refer to

Maintenance"

for information on adding helium to the Compressor.

Part Number 8040437, Revision 104, 06/12/2007, ECO Number 18068

"Section 5 -

1-9

Table of Contents