Sleep Timer - Sharp SD-AS10 Operation Manual

Sleep timer

The unit turns off at a specified time when listening to a disc or the radio.
1
During playback, press the TIMER/SLEEP/CLOCK button.
2
Within 10 seconds, press the
select "SLEEP", and press the ENTER button.
3
Press the or button to select the time.
The default is 60 minutes. Time changes by 5 minutes
(5 - 120) and decreases by 1 minute (5 - 1).
4
Press the ENTER button.
! The unit will enter the power stand-by mode auto-
matically after the preset time has elapsed.
! The volume will be turned down 1 minute before the sleep operation finishes,
and then you cannot change the volume.
or button to
To confirm the remaining sleep time:
1 Press the TIMER/SLEEP/CLOCK button.
2 Within 10 seconds, press the or
When the remaining time appears, you can change the time.
To cancel the sleep operation:
Press the POWER button while "SLEEP" is indicated.
To cancel the sleep operation without setting the unit to the stand-by mode, proceed
as follows.
1 Press the TIMER/SLEEP/CLOCK button.
2 Within 10 seconds, press the or
"SLEEP OFF".
3 Within 10 seconds, press the ENTER button.
("SLEEP" goes out.)
" To use timer and sleep operation together
For example, you can fall asleep to the radio, and wake up to CD.
1 Set the sleep time (steps 1 - 4).
2 Set the timer playback (steps 1 - 8, page 51).
Make sure timer playback does not start while sleep timer is active.
The unit enters into the power stand-by mode after the time set for sleep timer, and
turns on at the start time of timer playback.
1
Sleep timer setting
2
Timer playback setting
1 minute - 2 hours
1minute - 2hours
Sleep operation will
Sleep operation
automatically stop.
starts.
button to select "SLEEP".
button to select
Start time Finish time
Desired time
Timer playback Timer playback will
starts. automatically stop.
SD-AS10
53