Table of Contents
Advertisement
" Tuner
Symptom
! Is the unit placed near the TV or
The radio makes unusual
noises continuously.
computer?
! Is the FM antenna or AM loop anten-
na placed properly? Move the an-
tenna away from the AC power cord
or the unit if located near.
! Did you remove the plug from the
The preset channel cannot
be recalled.
AC outlet, or did a power failure oc-
cur?
Preset the channel again.
" Remote control
Symptom
! Is the battery polarity respected?
The remote control does not
operate properly.
! Are the batteries dead?
! Is the distance or angle incorrect?
! Are there any obstructions in front of
the unit?
! Is the remote control sensor ex-
posed to strong light (inverter fluo-
rescent light, direct sunlight, etc.)?
! Is the remote control for another
equipment used simultaneously?
! Is the AC power cord of the unit
The unit cannot be turned on
with the remote control.
plugged in?
! Are the batteries inserted?
! Is the MODE 1/MODE 2 switch set
The unit performs unintend-
ed operations.
correctly?
Possible cause
Reference
page
P. 39
Possible cause
Reference
page
P. 20
P. 20
P. 20
P. 20
P. 20
P. 12, 13
" Condensation
Sudden temperature changes, storage or operation in an extremely humid environ-
ment may cause condensation inside the cabinet (laser pickup, etc.) or on the trans-
mitter on the remote control.
Condensation can cause the unit to malfunction. If this happens, leave the power on
with no disc in the unit until normal playback is possible (about 1 hour). Wipe off any
condensation on the transmitter with a soft cloth before operating the unit.
" If trouble occurs
When this product is subjected to strong external interference (mechanical shock,
excessive static electricity, abnormal supply voltage due to lightning, etc.) or if it is
operated incorrectly, it may malfunction.
If such a problem occurs, do the following:
1
Set the unit to the stand-by mode and turn the power on again.
2
If the unit is not restored in the previous operation, unplug and plug in the unit, and
then turn the power on.
Note:
If neither operation above restores the unit, clear all the memory by resetting it.
Clearing all the memory (reset)
1
Press the POWER button to enter the power stand-by mode.
2
While holding down the DISC 5 button and the STOP button, press the POWER
button for 2 seconds or more.
3
When "ALL CLEAR" appears, press the POWER button to enter the stand-by
mode.
4
Press the POWER button again to turn on the unit.
Caution:
! When you reset, all data is deleted and the settings return to the default. (DVD ini-
tial settings are retained.)
! If problem occurred, the power turns off and the timer set indicator will blinking.
SD-AS10
61
Advertisement
Table of Contents
