Replacing Your Water Optimizer's Filters; Maintaining Your Water Optimizer - Kenmore KM1000 Use & Care Manual

Freestanding purifier dispenser
Hide thumbs Also See for KM1000:
Table of Contents

Advertisement

Maintaining Your Water Optimizer

Replacing Your Water Optimizer's Filters

Your Water Optimizer is equipped with a
when you need to change your pod filters (based on typical usage). This reminder
is controlled by a timer that will change the
every six months. This timer can be reset by following the last step in this section.
To maximize filter and appliance lifespan, it is very important to always flush the
F1
ULTRA+3 Hybrid
F5
Polishing Filter
Water Optimizer.
For this step, you will need a towel, a container to catch water, and your
Setup
you assembled during installation.
Z
1. Unplug
110v Power Cord
2. Shutoff water flow to your appliance by turning the blue handle on the
1/4 in. Quick Connect Shutoff Valve
BB
Optimizer's
3. Place your container below the
Ambient Dispense Mode
Dispense Button
flow stops.
4. If you aren't replacing the
listed above), you can skip ahead to
5. Disconnect the tubing running between our Optimizer's
C
the
1/4 in. Quick Connect Shutoff Valve
tubing into the container to catch any water that drains back.
6. Connect the open end of the tubing from your
1/4 in. Quick Connect Shutoff Valve
7. Connect the filter(s) listed above that you are replacing to the
G
Filter Flushing Attachment,
Filter, or alternative
(if purchased separately), prior to installing them into your
from the electrical outlet.
Source Input Port
O
Button, quickly followed by pressing and holding the
to depressurize the system, by dispensing water into a cup until water
F1
ULTRA+3 Hybrid Filter (or one of the alternative filters
and flush by opening the
I
Pod Filter(s) Status Light
Pod Filter(s) Status Light
F3
Chemical Filter
(see Installation Guide)
located at the back of the appliance.
Water Dispenser
"Step 9" on page
you just shutoff, and place end of the
G
Filter Flushing Setup
that you just disconnected.
to indicate
from white to red
and the
Filter Flushing
C
connected to your
Nozzle, then press the
14.
BB
Source Input Port
C
Maintaining Your Water Optimizer 13
K
N
and
C
to the

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Km1000b

Table of Contents