Using Your Water Optimizer
This guide will explain how to use, maintain, and troubleshoot your new Water Optimizer.
Be sure to complete all of the applicable instructions in the Installation Guide,
included with your Optimizer prior to using the appliance.
Powering On/Off Your Optimizer
Be sure to never plug in your Optimizer, or power on either temperature mode
before you've connected a proper water source, and enabled water flow.
1. To power on your Water Optimizer, simply plug in
electrical outlet. To power off, unplug the appliance.
2. To power on the
left) up, into the on position. To power off, flip back down.
3. To power on the
into the on position. To power off, flip back down.
Dispensing water can be accomplished by pressing 1 - 3 buttons, depending on the situation.
What temperature of water is dispensed (temperature modes), and the amount of water
that is dispensed (dispense modes) can be selected by pressing the temperature and
dispense mode buttons. By default, your Water Optimizer is set to (and will always return
simply be triggered by pressing or holding the
1. For non-default usage, start by selecting your temperature mode of choice, by
pressing one of the following buttons.
Hot Dispense Mode Button
button to be pressed within 5 seconds of selecting hot mode.
Ambient Dispense Mode Button
Cold Dispense Mode Button
Next, select your preferred dispense mode by following the relevant instructions
for that specific mode.
system, flip the green
system, flip the red
can be triggered by simply pressing and holding your finger down
Cold Mode Power Switch
Hot Mode Power Switch
Child Safety Lock
110v Power Cord
Mode, which can
function requires dispense
Using Your Water Optimizer 9
into a 110 volt