Connecting Water Optimizer - Kenmore KM1000 Installation Manual

Installing Your Water Optimizer

Connecting Water Optimizer

Congratulations! You are now close enough to the end that you should be able to taste it.
This is the second easiest of the final stages.
You should either have one or two water lines that end in
1/4 in. Quick Connect Shutoff Valve(s)
new Water Optimizer. The first (or only) should be from your Water Source or
1/4 in. Brass Compression Tee
your Line. The second (if applicable) should be from your Accessory Appliance, or
Source
1/4 in. Brass Compression Tee
as your Accessory
1. Move your new Water Optimizer to its final location. Do not plug the power cord in yet.
2. Cut final short section(s) of tubing from
C
1/4 in. Quick Connect Shutoff Valve(s)
sure to include enough additional length to allow you to pull your Optimizer away from
the wall (for maintenance).
3. Now connect the section(s) of
C
the
1/4 in. Quick Connect Shutoff Valve(s)
Accessory Line
(for
Parallel
if you have 2 Accessory Appliances. We will refer to this
Line.
A
(if applicable). Use the standard quick connect method to attach them.
Diagram 2.7.3 Connect Tubing To Shutoff Valve
C
running to where you plan on locating your
Configuration). We will refer to this line as
A
1/4 in. White PP Tubing
to your Water Optimizer's ports. Be
1/4 in. White PP Tubing
of your
to run from the
to the open port(s) on
and
Source Line
Installing Your Water Optimizer 2-43
E