Maintaining Your Water Optimizer
1/4 in. Quick Connect Shutoff
to aim the water outlet on the attachment into your container.
8. Now, disconnect the
1/4 in. Quick Connect Shutoff Valve
9. Next, if replacing the internal filter, open the
finger into the opening at the top, and pulling lightly down and outward.
10. Lay a towel down across the base of the internal filter cavity, to catch any water that
drips down, and prevent triggering
11. Replace the applicable filter(s) in the location(s). Filters can be removed by
twisting counter clockwise. To insert new filters, press filter upward into the
Internal Filter EZ-twist Mount
while twisting clockwise.
ULTRA+3 Hybrid Filter (DEFAULT - Internal Filter Slot)
12. Reattach the
13. Open the
14. Place your container below the
Ambient Dispense Mode
water is steadily dispensing, you can stop.
110v Power Cord
16. Finally, press and hold the
the timer and
Maintaining Your Water Optimizer 14
Valve, until the water exiting the filter is clear. Be sure
Filter Flushing Setup
(DEFAULT/OPTIONAL - External Filter Slot)
(Alternative - Internal Filter Slot)
(Alternative - External Filter Slot)
1/4 in. Quick Connect Shutoff Valve,
until water flow is constant, to repressurize the system. Once
back into the electrical outlet.
ECO Mode/Filter Rest Button
Pod Filter(s) Status
and reattach it to the
Internal Filter Door
External Filter EZ-twist Mount
Door, and discard the old filter(s).
Water Dispenser Nozzle
Button, quickly followed by pressing and holding
Light. You're finished!
Source Input Port
by inserting your
to enable water flow.
one last time, then press
for 5 seconds to reset
(if in use)