Maintaining Your Water Optimizer
MAINTAINING YOUR WATER OPTIMIzER
Replacing Your Water Optimizer's Filters
To maximize filter and appliance lifespan, it is very important to always flush the
F2
Chemical Filter
Water Optimizer.
For this step, you will need a towel, a container to catch water, and your
you assembled during installation.
Setup
U
1. Unplug
110v Power Cord
2. Shutoff water flow to your appliance by turning the blue handle on the
1/4 in. Quick Connect Shutoff Valve
Y
Optimizer's
3. Place your container below the center dispenser, and press the
Ambient Mode Button
4. If you aren't replacing the
skip ahead to
"Step 9" on page
5. Disconnect the tubing running between our Optimizer's
C
the
1/4 in. Quick Connect Shutoff Valve
tubing into the container to catch any water that drains back.
6. Connect the open end of the tubing from your
1/4 in. Quick Connect Shutoff Valve
7. Connect the filter(s) listed above that you are replacing to the
G
Filter Flushing
1/4 in. Quick Connect Shutoff Valve,
to aim the water outlet on the attachment into your container.
8. Now, disconnect the
1/4 in. Quick Connect Shutoff Valve
9. Next open the
10. Lay a towel down across the base of the bottom plate, to catch any water that drips
F4
and the
Polishing Filter
from the electrical outlet.
Source Input Port
to depressurize the system, by dispensing water into a cup.
F2
Chemical Filter
9.
Attachment, and flush by opening the
G
Filter Flushing Setup
M
Stainless Steel Cabinet Door
prior to installing them into your
(see Installation Guide)
located at the back of the appliance.
or the
you just shutoff, and place end of the
Filter Flushing Setup
that you just disconnected.
until the water exiting the filter is clear. Be sure
from the
and reattach it to the
by pulling outward on the right side.
Filter Flushing
C
connected to your
C
F4
Polishing Filter
Y
Source Input Port
to the
C
C
Y
Source Input Port
Maintaining Your Water Optimizer 9
you can
and
C