Mile Marker PE4500 ES Installation And Operator's Manual page 13

Control Box Installation Cont'd
Wiring the Control Box
1. Slips the boots onto pertinent cables and make electrical
connection in accordance with the schematic on following
page. Slide the boots onto all the electrical connections
made (figs. 2-12 through 2-14).
2. Run battery power cables carefully under hood of vehicle,
avoiding interference with moving parts and abrasion points
which could potentially cause electrical short.
3. Attach Black Cable to Negative Battery Terminal (-), fol-
lowed by Red Cable to Positive Battery Terminal (+) (fig.
2-14). Refer to Winch Operation Section of this manual for
proper functioning; if drum rotates in the incorrect direction
when "IN" button is pressed, green and yellow motor cables
need to be switched.
CAUTION: Do Not Connect Cables to Battery until unit
is completely wired to control box and installed on ve-
hicle. Reserve for last step of installation.
CAUTION:
Make sure that all exposed electrical connections
are covered with insulation boots to avoid electrical short.
Battery cables should not be drawn taut; leave some slack for
cable movement. Also, ensure that they are routed properly
with out any interference with the vehicular components that
could potentially damage the cable or cause electrical short.
Long battery cable runs may have significant voltage drops
that may cause the winch motor controller to not operate.
2-12: Complete Wiring Schematic: SEC8
2-13: Black Cables (ground): Remove bolt, Attach both large and small cables,
2-14: Complete Wiring to Battery
CAUTION: Do Not Connect Cables to Battery until unit
is completely wired to control box and installed on ve-
hicle. Reserve for last step of installation.
13
and return bolt to motor.