Mile Marker PE4500 ES Installation And Operator's Manual page 12

Control Box Installation Cont'd
Mounting Control Box on Tiebars
1. Mount the control box to mounting brackets using 10 mm
wrench (Fig 2-8).
2. Mount control box on the tie bars by attaching front end first
and pushing down to snap in the back end (Fig. 2-9).
3. Locate the two extra pieces for the tie bars mounting brackets
(Fig. 2-10).
4. Screw in these pieces to the rear side of the tie bar bracket
using a Philips Head Screw Driver (Fig. 2-11).
2-10: Locate the extra pieces for the Tie Bar Mountin Brackets.
2-8: Install the mounting bracket to the bottom of the control box with a 10mm
wrench.
2-11: Screw in pieces to the rear of the Brackets.
2-9: Mount Control Box on the Tie Bars.
12