Setting The Configuration Mode; Recognizing The Cpi Extension With The Save Button; Help Table For Setting The Bus Address - Festo CPV...-GE-CO3-8 series Electronic Manual

1. Installation

1.2.4 Setting the configuration mode

1.2.5 Recognizing the CPI extension with the SAVE button

1.2.6 Help table for setting the bus address

Festo P.BE-CPV-CO3-EN en 1201a
You can set the string configuration with switch element 8 of
the 8-element DIL switch.
String configuration
Normal mode
Tool change
configuration
Tab. 1/4: Setting the string configuration on the 8-element
DIL switch
When the SAVE button is pressed, the CPI/CP modules con-
nected to the CPI extension connection will be recognized
automatically. This can only take place in normal mode.
1. Prepare to connect the CPV Direct to the power supply
(see section 1.5).
2. Carry out the CPI extension according to the sections 1.6
"Extending the CPV Direct" and 1.7 "Preparing the
CPI system for commissioning".
In the tool change configuration, pressing the SAVE button is
not necessary. Please refer here to section 2.4.
On the following pages you will find an overview on setting
the bus address.
Position of the switch elements
DIL 2.8 = off
DIL 2.8 = on
1-9