Messages And Signals - Sharp UX-D50 User Manual

all.book Page 130 Monday, September 1, 2003 3:46 PM

Messages and Signals

Messages and Signals
Display messages (fax machine)
Note: If you have turned on the Caller ID function, see page 109 for display
messages related to Caller ID.
ADD PAPER & /
PRESS START KEY
(alternating messages)
A.M. TRANSFER
CALL TRANSFER
CHECK FILM/
CHECK COVER/
CHECK PAPER JAM
(alternating messages)
CHECK PAPER SIZE
DECT HS IN USE
DOCUMENT JAMMED
130
Check the printing paper. If the tray is empty, add
paper and then press the START/MEMORY key. If
there is paper in the tray, make sure it is inserted
correctly (take out the stack, align the edges evenly,
and then reinsert it in the tray) and then press the
START/MEMORY key.
The answering system's transfer function has been
turned on (see page 71).
A call is being transferred.
These alternating messages appear when there is a
problem in the print compartment that prevents
printing. Check to see if the imaging film is not loaded
properly or if it has been used up and needs
replacement. Make sure the operation panel is
completely closed (press down on both sides). If a
paper jam has occurred, clear the jam as explained in
the following section, Clearing Paper Jams.
An incorrect size of paper has been loaded in the
paper tray. Remove the paper and load A4-size
paper.
The cordless handset is in use. Wait until this
message no longer appears to send a fax or make a
phone call from the fax machine.
The original document is jammed. See the following
section, Clearing Paper Jams. Document jams will
occur if you load more than 10 pages at once or load
documents that are too thick (see page 82).