Operating The Answering System - Sharp UX-D50 User Manual

all.book Page 65 Monday, September 1, 2003 3:46 PM
START/SPEICHER
4
Press
•
The outgoing message can be up to 60 seconds long. While recording, the
display will show the time left to record.
5
When finished, replace the handset or press
To listen to the outgoing message
To listen to the outgoing message, follow Steps 1 and 2 of the above
procedure and then press
message cannot be erased. If you need to change it, simply repeat the
recording procedure.

Operating the Answering System

Activating the answering system
To turn on the answering system so that callers can leave messages, press
AUFLÖS./
EMPFANG
until the arrow in the display points to A.M.
♦
The outgoing message will play (you can stop playback by pressing
STOP
).
♦
It will not be possible to set the reception mode to A.M. if an outgoing
message has not been recorded.
and speak into the handset to record a message.
WIEDERG./
. Note that the general outgoing
HALTEN
AUFLÖS./
EMPFANG
Operating the Answering System
STOP
.
TEL FAX
TEL/FAX AB
65