Messages And Signals - Sharp FO-50 Operation Manual

Messages and Signals

Display messages
Note: If you have turned on the Caller ID function, see Caller ID in Chapter 7
for display messages related to Caller ID.
CHECK PAPER
COVER OPEN
DOCUMENT JAMMED
FUNCTION MODE
HOLD
LINE BUSY
LINE ERROR
NO DATA
NO # STORED
OFF HOOK
All manuals and user guides at all-guides.com
The thermal paper is jammed or isn't loaded properly.
Remove and reload the paper. (See the following
section, Clearing Paper Jams.)
The operation panel is open. Close it.
The original document is jammed. See the following
section, Clearing Paper Jams.
The FUNCTION key has been pressed.
The HOLD/SEARCH key has been pressed to put the
other party on hold during a phone conversation.
Press the HOLD/SEARCH key again to take the
other party off hold.
This appears if you attempt to send a fax by
automatic dialing and the line is busy or the receiving
fax machine doesn't answer (even after automatic
redialing). Press the STOP key to clear the message.
Transmission or reception was not successful. Press
the STOP key to clear the message and then try
again. If the error persists, see Line Error in Problems
and Solutions in this chapter.
This appears if you attempt to search for an
automatic dialling number when none have been
stored.
You have tried to dial or clear a Rapid Key or Speed
Dial number that hasn't been programmed (a full
number hasn't been assigned to it).
This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press the STOP key to clear the message.
Messages and Signals
95