Table of Contents
Advertisement
all.book Page 24 Monday, September 1, 2003 3:46 PM
Loading the Imaging Film
4
Remove the new roll of imaging film
from its packaging.
•
Cut the band that holds the rolls
together.
5
Insert the green gears.
6
Insert the film into the print
compartment.
Thick roll
to rear
7
Rotate the front gear as shown until
the film is taut.
8
Close the operation panel (press down
on both sides to make sure it clicks
into place).
24
1 slot
Make sure the
gears fit into the
slots in the ends
of the rolls.
Fit ends of rolls
onto hubs
2 slots
- Quick Links:
- Recording an Outgoing Message
Hide quick links:
Advertisement
Table of Contents
