Table of Contents
Advertisement
Print Settings
Make a selection for the displayed setting as explained below.
This is done in step 3 of the procedure on page 49.
Setting
Description
RECEIVE
Press
RATIO
size of received faxes to fit the size of the printing paper. This
ensures that the edges of a fax are not cut off. (Note: AUTO may
not operate if the received fax is too long, contains many fine
graphics or images, or is sent at high resolution. In this case, the
remainder of the fax will be printed on a second page.) Press
long to fit on the paper, the remainder will be printed on a second
sheet; note that the cut-off point may occur in the middle of a line).
Initial setting: AUTO
SORT COPY
This setting determines whether or not copies are collated (sorted
into sets) when multiple copies of each original page are made.
Press
(NO) to have copies grouped by page.
Initial setting: NO
INK SAVE
To use less ink and speed up ink drying time when printing faxes
MODE
and copies, press
prefer a higher quality image, press
Save Mode.
Initial setting: OFF
QUALITY
To have the machine print higher quality images by printing slowly
MODE
when the resolution is set to HALF TONE, press
turn on Quality Mode. If you prefer faster printing at the expense of
slightly reduced image quality when using HALF TONE, press
(Note: This setting does not affect the amount of ink used.)
Initial setting: YES
(AUTO) to have the machine automatically reduce the
(100%) to have all faxes printed at full size (if a fax is too
(YES) to have copies automatically sorted, or
(ON) to turn on Ink Save Mode. If you
(NO) to turn off Quality Mode.
Print Settings
(OFF) to turn off Ink
(YES) to
53
Advertisement
Table of Contents
