Table of Contents
Advertisement
Messages and Signals
SERVER ERROR
SERVER ERROR/
SMTP-AUTH
SERVER NOT FOUND/
CABLE DISCONNECTED
SERVER NOT FOUND/
DHCP
SERVER NOT FOUND/
SMTP
Audible signals
Continuous tone
Intermittent tone
(3 beeps)
66
A Scan to E-mail transmission was not successful
because the machine could not connect to your mail
server or there was no response from the mail server.
Make sure the SMTP server setting is correct (p. 19). If
you have configured "SMTP Authentication" settings or
"POP before SMTP" settings in the machine's Web
pages, make sure these settings are correct (p. 17). If
[CABLE DISCONNECTED] appears on the bottom line,
see "CONNECTION ERROR" on page 64.
A Scan to E-mail transmission was not successful
because your SMTP server requires SMTP
authentication and the SMTP authentication user name
or password entered in the machine's Web page is not
correct (p. 17).
See "CONNECTION ERROR" on page 64.
A Scan to E-mail transmission was not successful
because the machine was unable to automatically obtain
an IP address. Restart your router or other device that
acts as your DHCP server.
A Scan to E-mail transmission was not successful
because an incorrect host name is entered for your
SMTP server. Check the SMTP server setting (p. 19).
3 seconds
5 seconds
(1 second on, 1
second off)
Indicates the end of transmission,
reception, or copying.
Indicates incomplete transmission,
reception, or copying.
Advertisement
Table of Contents
