Table of Contents
Advertisement
Diagnostic - LEDs of the
BK7500
I / O RUN
PHASEL
PHAESH Optical
lit
lit
lit
lit
off
lit
lit
lit
off
off
lit
off
off
off
off
Setting
the
transmission
rate in the BK7500
Setting the cable length to
the next device
BK7500
Meaning
fibres
off
Telegrams are passing cyclically along the ring
Inputs are read and outputs are set.
off
The SERCOS ring is in phase 3
off
The SERCOS ring is in phase 2
off
The SERCOS ring is in phase 1
off
The SERCOS ring is in phase 0
Attention must be paid to the fact that there is a connection between the
green I/O LED and the field bus. The I/O LED lights up in connection with
access to the internal K-bus. The green I/O LED does not light up until a
trigger begins via the field bus. This means that the field bus must access
the bus coupler and the controller software must clear a cyclical trigger.
The green I/O LED indicates access to the internal K-bus and is reset after
100 ms.
The bus coupler queries the configuration of the bus terminals after
switching on and does not exchange data with the terminals. That is to say,
the red I/O LED goes off after an error-free startup without the green I/O
LED having to light up. The green I/O LED does not light up until data
exchange is begun via the Beckhoff-Lightbus.
Setting the Transmission Rate
2 Mbd
4 Mbd
Setting the Cable Length
The cable length is set at the coupler in the following stages: 0...15, 15...30
and 30...45 m. This is necessary in order to adapt the transmission power
to the cable attenuation.
0 .. 15 m
15 .. 30 m
Basic information
Remedy
8 Mbd
16 Mbd
30 ..45 m
19
Advertisement
Table of Contents
