Table of Contents
Advertisement
Basic information
Error code
Error code
argument
Persistent,
continuous
blinking
1 pulse
0
1
2
2 pulses
0
n (n > 0)
3 pulses
0
4 pulses
0
n
5 pulses
n
6 pulses
0
1
2
7 pulses
Fieldbus error
18
Terminal bus error
Description
EMC problems
EEPROM checksum error
Inline code buffer overflow
Unknown data type
Programmed configuration
Incorrect table entry / bus
coupler
Incorrect table comparison
(terminal n)
Terminal bus command error
Terminal bus data error
Break behind terminal n (0:
coupler)0
n
Terminal bus error with register
communication with terminal n
No ident of the MDT
No ident of the AT
Ident im MDT ans S370
konfigurated
Klemme wird vom Koppler nicht
unterstützt
Fieldbus error
The fieldbus status LEDs indicate the operational state of the fieldbus. The
functions of the SERCOS are indicated by the LED "PHASEL", PHASEH",
"LWL" and "DIAG".
The meaning of the first 4 LED`s:
PHASEL Communication phase low
PHASEH Communication phase high
DIAG
without function
LWL
shows quality of the fibre optic connection
Remedy
- Check power supply for overvoltage or
undervoltage peaks
- Implement EMC measures
- If a K-bus error is present, it can be
localised by a restart of the coupler (by
switching it off and then on again)
- Set manufacturer's setting with the
KS2000
- Connect fewer terminals; too many
entries in the table for the programmed
configuration
- Software update required for the coupler
- Check programmed configuration for
correctness
- Incorrect table entry / bus coupler
- No terminal connected; attach terminals.
- One of the terminals is defective; halve
the number of terminals attached and
check whether the error is still present with
the remaining terminals. Repeat until the
defective terminal is located.
- Check whether the n+1 terminal is
correctly connected; replace if necessary.
– Check whether the end terminal 9010 is
connected.
Replace terminal n.
BK7500
Advertisement
Table of Contents
