Extreme Networks ExtremeAnalytics PV-A-305 Installation Manuals page 19

=================================================================
The following information will be used to configure SNMP management of this device. The
SNMP information entered here must be used to contact this device with remote
management applications such as Extreme Management Center Console.
=================================================================
Please enter the SNMP user name [snmpuser]:
Please enter the SNMP authentication credential [snmpauthcred]:
Please enter the SNMP privacy credential [snmpprivcred]:
13 A summary screen appears asking you to accept your SNMP Configuration settings. Enter 0 to
accept the settings.
======================================================================
SNMP Configuration
======================================================================
These are the current SNMP V3 settings. To accept them and complete SNMP configuration,
enter 0 or any key other than the selection choices. If you need to make a change,
enter the appropriate number now or run the /usr/postinstall/snmpconfig script at a
later time.
0. Accept the current settings
1. SNMP User: snmpuser
2. SNMP Authentication: snmpauthcred
3. SNMP Privacy: snmpprivcred
4. Modify all settings
======================================================================
Enter selection [0]: 0
14 In the Configure Date and Time Settings screen, select whether you want to use an external Network
Time Protocol (NTP) server. Enter y to use NTP, and enter your NTP server IP address(es). Enter n to
configure the date and time manually and proceed to step 15.
=================================================================
Configure Date And Time Settings
=================================================================
The engine date and time can be set manually or using an external
Network Time Protocol (NTP) server. It is strongly recommended that
NTP is used to configure the date and time to ensure accuracy of time
values for SNMP communications and logged events. Up to 5 server IP addresses may be
entered if NTP is used.
=================================================================
Do you want to use NTP (y/n) [y]? y
Please enter a NTP Server IP Address (Required): 144.131.10.120
Would you like to add another server (y/n) [n]? y
Please enter a NTP Server IP Address (Required): 144.131.10.121
Would you like to add another server (y/n) [n]? n
15 In the NTP Servers validate selection screen, enter 0 to accept the current settings and proceed to
the Set Time Zone screen at step 17.
=================================================================
NTP Servers
=================================================================
These are the currently specified NTP servers. Enter 0 or any key other than a valid
selection to complete NTP configuration and continue.
If you need to make a change, enter the appropriate number from the choices listed
below.
144.131.10.120
144.131.10.121
0. Accept the current settings
1. Restart NTP server selection
2. Set date and time manually
=================================================================
Enter selection [0]: 0
16 If you answered "no" to using an NTP server to set date and time, set the date and time in the Set
Date and Time screen.
=================================================================
Set Date And Time
ExtremeAnalytics® PV-A-305 Installation Guide for version 8.1
Configuration
19