Preparation; Entering The Mmsi Code - Icom IC-M220 Instruction Manual

3

PREPARATION

■ Entering the MMSI code

The Maritime Mobile Service Identity (MMSI: DSC self ID) code consists of 9 digits.
You can only enter the code when turning ON the transceiver for the first time.
This initial code can be entered only once.
After entering, it can be changed only by your dealer or distributor.
If your MMSI code has already been entered, doing the steps below is not necessary.
1. Hold down [PWR] to turn ON the transceiver.
• Three short beeps sound, and "Push [ENT] to Register
your MMSI" is displayed.
2. Push [ENT] to start entering the MMSI code.
• The "MMSI Input" screen is displayed.
L Push [CLR] twice to skip the entry.
If you skip the entry, you cannot make a DSC call. To
enter the code after skipping, turn OFF the power, and
then turn it ON again.
3. Enter the MMSI code.
TIP:
• Select a number using [◄] and [►].
• Push [ENT] to enter the selected number.
• Select "←" or "→" on the screen to move the
cursor.
4. Repeat step 3 to enter all 9 digits.
5. Push the software key below
code.
• The "Confirmation" screen is displayed.
6. Enter your MMSI code again to confirm.
FIN
7. Push
• When your MMSI code is successfully entered, "MMSI
Successfully Registered" is briefly displayed, and then
enters the operating screen.
L Your MMSI code is also displayed on the opening screen.
6
FIN
to set the entered code.
to set the entered