Icom IC-M220 Instruction Manual page 41

D Receiving a Position Request call
(May not be used, depending on the presetting)
NOTE: Even if the Auto ACK function is set to "Manual," after receiving a Distress
Acknowledgement, or while in the Distress Cancel call procedure, the Position Reply is
automatically sent to the calling station.
When a Position Request call is received:
• An alarm sounds.
• "RCVD POS Request" is displayed.
ALARM OFF
1. Push
2. Push the Software Key below the intended operation.
Ignores the call and returns to the
IGN
:
operating screen.
(Ignore)
• The call is saved in the DSC Log.
• "
the call message.
Sends Acknowledgement "Able to
ABLE :
comply" right away.
( Able to
comply)
Sends an Acknowledgement "Unable to
Comply."
UNABLE
:
• The call is saved in the DSC Log.
(Unable to
• Displays the Acknowledgement
Comply)
information, and then returns to the
operating screen by pushing
Accepts the call.
ACPT
:
• Displays the received call's information.
(Accept)
• The call is saved in the DSC Log.
Push
send the Position Reply call. (p. 27)
DIGITAL SELECTIVE CALLING (DSC)
to turn OFF the alarm.
" blinks continuously until you display
ABLE UNABLE
or , then push
EXIT
.
CALL
to
7
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
31