Kenmore KM1000 Installation Manual page 37

Installing Your Water Optimizer
CONFIGURATION OF ACCESSORIES
1x
A.
acc.
2x
B.
acc.
P
C.
acc.
For safety reasons, we recommend powering off and unplug the appliances you
want to connect.
NOTE REGARDING LOW WATER PRESSURE
P
acc.
While it is not typical, be aware that sufficient water pressure is required for the optimal
experience. Insufficient water pressure to your Water Optimizer will degrade outgoing water
flow, and in rare worst cases, even prevent the feature from functioning. If you experience any
of these issues, we recommend speaking with a professional plumber.
If your water pressure cannot be resolved, we do offer an Alternative Ice Maker Configuration
for users that have chosen a Accessory Water Line as their source. This
Configuration" (see page 2-8)
chained.
Identify
1. If you haven't already, look at the back of your appliance(s), and identify which of the
above listed connection(s) you will be connecting to. Only follow the directions with the
relevant icon(s), and skip the others.
Location
2. If you are planning to have
2x
acc.
E
to 1/4 in. Brass Compression Tee
Accessory Output Port
corner of right exterior
connect to the Brass Compression Tee wherever is most convenient. Just be sure to allow
enough length when cutting sections of
appliance has a hose (rather than port) that isn't long enough to reach, follow the
instructions below for
If you are only connecting
If you are connecting
If you have low water pressure and require the
below).
allows the water flow to be shared, rather than daisy-
2 Accessory
(see Use & Care Guide or In/Out sticker on bottom rear
panel) on your Water Optimizer. You can locate where they
"Extending" on page
1 Accessory Appliance.
2 Accessory Appliances.
Appliances, you will be connecting both
first, and then connecting that to
A
1/4 in. White PP
2-37.
Parallel Configuration
"Alternative
Tubing. Also, if your
Installing Your Water Optimizer 2-35
(see