Installing Your Water Optimizer
connection is almost certainly a ½ in. (Nominal/NPT) fitting. If you have a 15/16 in. and
a 1 in. wrench, you can check to confirm by attempting to loosen the connection (there
is 1/16 in. range of variance between different plumbing fittings). IF THAT DOESN'T FIT,
you have an extremely rare setup, and should contact a plumber. IF THE LARGER
WRENCH DOES FIT, we don't provide 1/2 in. adapter in your kit (only 2.5% of our
customers require it), but we'd be more than happy to ship you one for free upon request.
Call us at 1-844-374-6576, or email us at
want to wait, you can pick one up at your local hardware store. Ask for a
1/2 in. (MIP) x 1/4 in (OD) Push-to-Connect Angle Stop Adapter
6. Next, screw the bottom (female) end of
top (male) end of
using medium force with the same wrench (11/16 in.) you used to remove
Cold Water Feed Line.
Diagram 2.3(B).5 Detach Cold Water Feed Line
KS-F
Cold Water Shutoff Valve
support@drinkpod.com.
F
3/8 in. Sink Adapter Valve
using your hand. Then tighten
Installing Your Water Optimizer 2-19
Or, if you don't
1/2 in (FIP) x
Valve.
to the
KS-G