Kenmore KM1000 Installation Manual page 56

Installing Your Water Optimizer
5. You should hear water running and filling the Optimizer's tanks. Check for leaks, and wait
until the sound of water running stops.
6. Once the Optimizer is filled, plug it in, but do not flip on the power switches yet.
7. We need to flush each temperature mode. Start by flushing the
your large container for 30 seconds. Press the light blue
dispensing.
8. Now, for the best experience, we recommend flushing the full tank capacity for both the
Hot Mode and
and the Cold Tank
appliance, see the included
your Water Optimizer's control panel.
9. If you haven't connected any accessory appliances to your new Water Optimizer, you
are finished!!! You can now proceed to power on your Optimizer
Guide for instructions).
10. If you have connected accessory appliances, you can now open the
1/4 in. Quick Connect Shutoff Valve(s)
should now start flowing into your accessory appliances. Check the lines, valve, and
Installing Your Water Optimizer 2-54
Diagram 2.8.4 - Open Shutoff Valve
Cold Mode. For reference, the
capacity is 1.1 gal (4.16
Use & Care
Ambient Mode Button
Hot Tank capacity is
liters). For directions on how to flush your
Guide, or the
Quick Start Sticker
connected to your
Ambient Mode into
0.26 gal (1
applied to
(see Use & Care
C
Line. Water
Accessory
to begin
liter),