Running Water Source Line - Kenmore KM1000 Installation Manual

Installing Your Water Optimizer

Running Water Source Line

It's time to run your water line (tubing) from your water source to where your Optimizer will
be place. For this section, you will require
1. Uncoil and run
water source) to wherever you intend to locate your Optimizer. Make any necessary
adjustments (i.e. drilling holes) as you go.
2. Once you have the water line tubing ran all the way to where your Optimizer will be
placed, measure out a 1 - 2 ft. of additional tubing. You want to ensure you have sufficient
slack to pull the Optimizer away from the wall for maintenance.
3. Cut the tubing using your scissors or knife. Be careful to cut the tubing straight across (at
a 90 degree angle) to avoid leaks.
4. Now, insert the open end of
C
which) of
into opening until it won't go any further. Then pull tubing backwards (away) from valve,
using medium force, to engage/extend the compression sleeve on the valve, and ensure
the connection is secured.
A
1/4 in. White PP
Diagram 2.4.3 Cut Tubing
A
1/4 in. White PP Tubing
1/4 in. Quick Connect Shutoff Valve.
Tubing, from where its connected (to your
Continue to firmly insert tubing
into one end (doesn't matter
Installing Your Water Optimizer 2-23