Saving Screening Reports - PLUSOPTIX S12C Short Manual

2.1 Saving screening reports

After confirming the patient data entry or the anonymous, consecutive patient ID (see
supplementary short manual 4), a print job for label printing is sent via the infrared interface
and a screening report is saved to the inserted SD card (plusoptiX S12) or USB stick
(plusoptiX 16) at the same time.
Note:
The label can be printed on the wireless label printer "plusoptiX P12" and the
screening report can be printed manually or automatically on any printer that is
connected to your network or workplace computer. More information about
documenting the measurement results on paper can be found in supplementary
short manual 6.
Attention:
All print jobs in print spooler are deleted once device is switched off or switches
off for power saving automatically. Screening reports saved to a SD-card or USB
stick are not deleted when the "plusoptiX S12" is switched off or switches off for
power saving.
The screening report is used to document the measurement values and the last camera
image. For an anonymous measurement, the screening report is only saved to the SD card
(plusoptiX 12) or USB stick (plusoptiX 16) after entering or retrieving patient data or
confirming the consecutive patient ID number (see supplementary short manual 4).
Patient
information
info.png
2200 x 570 pixels
Figure 1: Example of a screening report (Letter-sized or DinA4)
Seite 4 von 8