ALLIANCE T30 Series Troubleshooting Manual page 32

Troubleshooting
7. Use screwdriver to remove spring from center
tab. Refer to Figure 5.
8. Lift spring, with attached clip, off drop.
9. Remove clip from spring. Refer to Figure 6.
Clip
Figure 6
10. Attach clip to new tension spring, Part No. 209/
00598/02.
11. Place clip, installed on spring, in slot on coin
drop. Refer to Figure 7.
Slot
Figure 7
30
MIX4B
MIX8B
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
12. Use a small flathead screwdriver to push spring
under center tab. Refer to Figure 8.
Left Tab
Figure 8
13. Lift spring gently to place in position under left
tab.
14. Push spring to right until it snaps into position.
Refer to Figure 4.
15. Close coin drop cover.
16. Move tension spring over cover catch. Refer to
Figure 3.
Reinstall Coin Drop Into Machine
1. Reinstall coin drop into machine.
2. Reconnect electrical power to machine and drop.
3. Add a coin to drop to verify that coin drop is
operating properly and that electrical connection
is working properly.
Center
Tab
Small Flat
Screwdriver
MIX5B
70291301