ALLIANCE T30 Series Troubleshooting Manual page 31

Troubleshooting Coin Drop
If coin drop is not accepting coins, perform the
following:
1. Clean coin drop. Refer to Paragraph 17.
2. On electronic coin drops with an old-style
tension spring (shown in Figure 1 and Figure 3),
test and replace tension spring using the
following instructions.
Remove Coin Drop From Machine
1. Disconnect electrical power to machine and drop.
2. Remove coin drop from machine.
Test Tension Spring
1. Push coin return button to open and close coin
drop cover to clear possible coin jams. Refer to
Figure 1.
Coin Return
Button
Figure 1
2. Manually hold down coin drop cover and insert
coin. Refer to Figure 2.
Figure 2
3. If coin drop now operates properly, replace
tension spring using instructions on following
pages.
70291301
Coin Drop
Cover
Tension Spring
MIX7B
Coin Drop
Cover
MIX6B
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Replace Tension Spring
1. Move tension spring downward until cover catch
is free. Refer to Figure 3.
Cover Catch
Figure 3
2. Open cover for coin drop.
3. Place a small flathead screwdriver under right
side of tension spring and lift up. Refer to
Figure 4.
Left Tab
Figure 4
4. Use screwdriver to move spring approximately 3
mm to left.
5. Lift spring over left tab. Refer to Figure 4.
6. Rotate spring clockwise, 40 to 60 degrees, until it
is free from right tabs. Refer to Figure 5.
Center Tab
Figure 5
Troubleshooting
Tension Spring
DRY2088N
Small Flathead
Screwdriver
Right Side of
MIX2B
Tension Spring
Tabs
MIX3B
29