Advantage Controls MegaTronMT Manual page 29

7.1 Flow Meter Setup
of the current settings.
RELAY LINK - The relay link informs the particular aux meter input is relevant to the control function that the
should be linked to the relay that is driven by the feed timer that pump will be controlled by. If the aux meter
is going to be linked to a water meter in a bleed of line then it should be linked to the relay that is controlling
VOLUME ALARM - If FloTracker has been selected as the Tracking method, an alarm will occur when the
Note:
RESET VOLUME - Resets the Volume Alarm totalizer.
METER LINK – This selection only shows if the tracking method is Rate and Volume and tells the auxiliary
meter inputs. If this is selected no wiring to the auxiliary input is required and the PULSE VALUE and UNITS
TRACKING - Provides a pop-up screen to select either FloTracker or Rate and Volume tracking.
8. Relays
PULSE VALUE
contact, i.e. 225.
UNITS
i.e. Pulses / Ounce.
RESET TOTAL - Resets the totalized count of the
meter.
VERIFY ALARM -
relay the controller will give an alarm if it does not receive
a contact or pulse from the aux meter within the amount of
STATUS - Allows for viewing accumulated relay ON
times, temporary forcing relays ON or OFF or seeing
which relay is on.
RESET - Allows the accumulated run time of a
particular relay to be reset to zero.
FORCE - Allows a relay to be manually forced ON
for a single event from 0-99 minutes. When the event
.
control
29