Advantage Controls MegaTronMT Manual page 27

5.5 Flow Switch
5.6 Temperature Scale
This menu is used to select the type of temperature scale to display.
5.7 Network
The Network menu is used when a controller is being remotely communicated with either a local network
connection or over the internet on the Web Advantage server.
IP Address, IP Mask, Gateway, and other information can be viwed from this menu.
5.9 System Information
serial number.
6. History
The onboard history allows for viewing the history of the probe readings, relay activations, key-pad activity,
calibrations, water meter hourly and daily logs and alarms for each system present. It is also where Notepad
data is entered and reviewed. An initial overview page is displayed showing your current sample interval, the
calculated number of days the unit can keep probe history for before losing the oldest. The number of sensor
samples and relay/alarm events and Notepad entries currently stored is also displayed.
SETTINGS - This menu is used for setting up the
remote WebAdvantage communications and is
covered in a separate manual.
http://www.advantagecontrols.com/downloads/pdf/M-WebAdvantage.pdf
Note: The Network card must be RESET after making any
changes to Network setting in order to save changes and
reset communications.
NOTE: The history can be reset by going to the
interval. After the new sample interval has been set
the onboard history is reset.
27