System Board Installation - Supermicro X10DRG-O+-CPU User Manual

2-3

System Board Installation

All boards have standard mounting holes to fi t different types of chassis. Make
sure that the locations of all the mounting holes for both motherboard and chassis
match. Although a chassis may have both plastic and metal mounting fasteners,
metal ones are highly recommended because they ground the motherboard to the
chassis. Make sure that the metal standoffs click in or are screwed in tightly. Then
use a screwdriver to secure the motherboard onto the motherboard tray.
Tools Needed
•
Phillips Screwdriver
•
Pan-head screws (14 pieces)
•
Standoffs (14 pieces, if needed)
Location of Mounting Holes
There are fourteen (14) mounting holes on this motherboard as shown below.
JPW21
CLOSE 1st
JPB1
J1
JPME2
JBR1
JWD1
JSPK1
JF1
1
JF1
PWR RST PS UID NIC NIC HDD PWR NMI
ON FAIL LED 2 1 LED LED
Caution: 1) To avoid damaging the motherboard and its components, please do
not use a force greater than 8 lb/inch on each mounting screw when installation the
motherboard. 2) Some components are very close to the mounting holes. Please take
precautionary measures to prevent damage to these components when installing the
motherboard to the chassis.
IPMI_LAN
USB5/6(3.0)
VGA
LAN2 LAN1
BMC
LAN
CTRL
JPW22
PCH
JBT1
USB2/3
BT1
1
X10DRG-O+-CPU
REV: 1.00
BAR CODE 1G/10G MAC CODE
BIOS LICENSE
IPMI CODE 10G SAN MAC
CLOSE 1st
CPU2
OPEN 1st
JPP2
JPP1
2-5
Chapter 2: Installation
JPW23 JPW24
JPW5
I-SGPIO2
I-SGPIO1
CPU1
LD1
OPEN 1st
LD2
JITP1