Vga Enable; Bmc Enable - Supermicro X10DRG-O+-CPU User Manual

VGA Enable

Jumper JPG1 allows the user to enable
the onboard VGA connector. The default
setting is on pins 1-2 to enable the con-
nection. See the table on the right for
jumper settings.

BMC Enable

Jumper JPB1 is used to enable or
disable the embedded AST2400 BMC
(Baseboard Management Controller)
that provides IPMI 2.0/KVM support on
the board. See the table on the right for
jumper settings.
Warning! Jumper JPB1 (BMC Enable) is for engineering debugging only. The manu-
facturer default setting is on pins 1-2 to enable BMC. Do not change the default set-
ting. Disabling BMC will disable onboard graphic controller, hardware monitoring and
system health management.
1
JPW22
JPW21
USB2/3
2
CLOSE 1st
JPB1
J1
CPU2
JPME2
JBR1
JWD1
OPEN 1st
JSPK1
JF1
1
JF1
PWR PS UID NIC NIC HDD PWR
RST FAIL LED 1 LED LED NMI
ON 2
Jumper Setting
Pins 1-2
Pins 2-3
IPMI_LAN
USB5/6(3.0)
VGA
LAN2 LAN1
BMC
LAN
CTRL
JPW23
PCH
JBT1
BT1
1
X10DRG-O+-CPU
REV: 1.00
BAR CODE 1G/10G MAC CODE
BIOS LICENSE IPMI CODE
10G SAN MAC
CLOSE 1st
CPU1
OPEN 1st
JPP2 JITP1
JPP1
2-33
Chapter 2: Installation
VGA Enable
Jumper Settings
Pin# Defi nition
1-2 Enabled (Default)
2-3 Disabled
BMC Enable
Jumper Settings
Defi nition
BMC Enable (Manufacture Default)
Disable (Do not use this setting!)
VGA Enabled
1.
BMC Enabled
2.
JPW24
JPW5
I-SGPIO2
I-SGPIO1
LD1
LD2