Grizzly G0791 Owner's Manual page 82

Ball Oilers
Oil Type .... Grizzly T23963 or ISO 32 Equivalent
Oil Amount ......................................1 or 2 Squirts
Lubrication Frequency ................................. Daily
This lathe has 11 ball oilers, as shown in Figures
135–138.
Ball Oilers
Proper lubrication of ball oilers is done with a
pump-type oil can fitted with a tip wide enough
to seal the ball oiler inlet. We do not recommend
using metal needle or lance tips, as they can push
the ball too far into the oiler, break the spring seat,
and lodge the ball in the oil galley.
Lubricate the ball oilers before and after machine
use, and more frequently under heavy use. When
lubricating ball oilers, first clean the outside sur-
face to remove any dust or grime. Push the tip of
the oil can nozzle against the ball oiler to create
a hydraulic seal, then pump the oil can once or
twice. If you see sludge and contaminants coming
out of the lubrication area, keep pumping the oil
can until the oil runs clear. When finished, wipe
away any excess oil.
A. Compound-rest leadscrew & slides
B. Saddle slides
C. Carriage handwheel
D. Tailstock ball oilers
E. Leadscrew end bearing
F.
Feed rod end bearing
A
Figure 135. Saddle and slide ball oilers.
-80-
B
C
Figure 136. Carriage handwheel ball oiler.
D
Figure 137. Tailstock ball oilers.
Figure 138. Leadscrew & feed rod ball oilers.
Model G0791 (Mfd. Since 9/15)
E
F